The JRPI or ZRPi-3.5NSX case allows you to elegantly combine the Raspberry Pi (not included), ZUMspot or JumboSPOT (not included), and a 3.5″ Enhanced Nextion Screen*, which is included. We go the extra mile to make sure everything we make feels solid and looks great. We use stainless steel hardware and acrylic to construct this case and guarantee you will love it as much as we do.
***Note: This case does not have a fan and the Pi-4 is known to run hot under use. It is not recommended to run the Pi-4 at full power for extended periods as performance problems can arise at higher temperatures.***
Notes on fit of Pimoroni Fan Shim (not included)
The clearance between the fan shim (not included) and most radio boards is very slim and not all boards will work with the fan shim if there are components or solder points above the fan.
The fan shim has been tested to work with the Zumspot versions 0.4, 0.5, 0.6 and MMDVM Duplex as long as there is no previous solder left over from an OLED screen.
The fan shim does NOT work with the N5BOC Lonestar Board***
For mmdvm and screen support visit: https://www.facebook.com/groups/Nextion/
The Nextion Enhanced NX4832K035 is a powerful 3.5″ HMI TFT display, with 32MB Flash data storage space, 1024 byte EEPROM, and 8192 byte RAM:
- supports built-in RTC
- supports save data to Flash
- supports GPIO
- larger flash capacity
- larger CPU clock
*Please note that connecting the Nextion screen to your set-up may require additional soldering of pins or wires not covered in these case instructions.
Fits (click image to enlarge):
Instructions (click image to enlarge):